Use the Chemical Filler Chemical Injector to add Chemicals Into Your Tanks-A-Lot Watering Machine
1. Measure the water
Fill your Tanks-A-Lot with water.
Empty your Tanks-A-Lot into a gallon bucket to determine the fill at different water sources.
2. Calculate correct amount
Read the instructions on the chemical used.
Adjust chemical manufacturer's instructions to the actual water input.
3. Fill Chemical Filler and secure lid
Remove Lid
Put measured chemical into blue base. (if using dry chemicals add water and stir until dissolved.
Screw lid back on, checking O-ring for correct seating and condition.
4. Connect Chemical Filler to water source
Use a male garden threaded hose or a faucet to connect the Chemical Filler's "IN".
Connect the Tanks-A-Lot red hose to the Chemical Filler's "OUT".
5. Fill your Tanks-A-Lot and spray
Open Ball-valve on Tanks-A-Lot hose BEFORE turning on the tap.
Turn on the tap.
When tank is full, turn of Ball valve on red Tanks-A-Lot hose.
Then turn off tap.
Put your favorite spray wand on the hose end.
Spray to chemical mixture anywhere you need.
Note:
Chemical FIller is flooded immediately with water. As soon as you open the tap, water flows through the Chemical Filler pushing chemicals into the tank.
Large Doses:
Sometimes it takes two or more Chemical Filler cups of chemical to get the ratio you need.
Within 30 seconds your first Chemical FIller load is emptied into the tank. To add a second load to the same tank follow these steps.
Turn off the Tanks-A-Lot hose Ball valve.
Turn off the tap and remove Chemical Filler.
These steps help keep your water supply clean. Chemical Fillers are sold with a check valve unless customer specifies no checkvalve.
