The Chemical Injector is used to get water soluble additives into the tank as it fills.
- Unscrew the black top assembly from the blue bottom reservoir of the injector.
- Be sure that the black "O" ring is properly seated in the groove of the blue, lower reservoir. This "O" ring provides a water tight seal. If the "O" ring is not in place correctly, the solution injector will leak.
- To achieve the proper concentration, make sure to confirm the correct dilution ratio of the additive (refer to the chemical manufacturer's instructions) and the water capacity of the tank to be used for this application.
- Put the water soluble additive in the blue reservoir. Then fill this reservoir to the "O" ring seal with water. This begins the dissolving process and eliminates air from the system. Screw the top assembly on firmly.
- Referring to the diagram below, screw the female brass GHT swivel onto the faucet. Then, connect the female GHT swivel on end of the Tanks-A-Lot hose to the male GHT fitting on the top assembly. NOTE: The top assembly is marked "IN" and "OUT" to indicate direction of flow.
- Turn on the faucet and check the lid for leaks. Fill the tank by twisting the Tanks-A-Lot hose's ball valve open. Water will flow through the solution injector mixing with the additive as the Tanks-A-Lot fills.
- When the tank is full, turn off the faucet and the Tanks-A-Lot ball valve. Disconnect the solution injector from the system.
How to use the ChemFiller outdoors. | THINGS TO REMEMBER
- Strictly adhere to all chemical manufacturer's instructions.
- Clean the solution injector by rinsing completely.
- Occasionally put some Vaseline on the "O" ring to keep it pliable and sealing properly.
- Drain tank solutions into a safe disposal receptacle.
|
